Kitronik

The MakeCode Arcade editor has been designed to allow everyone, from beginners to experienced game enthusiasts, to create retro arcade games to run in the browser or on handheld consoles. It consists of drag and drop blocks that snap together to form programs.<br/>The Kitronk ARCADE is packed full of features and has been designed to offer the perfect platform for running these games. The added resources available on the MakeCode Arcade website mean using this in schools couldnt be easier. A list of the features this board has to offer can be seen below Full colour LCD wide viewing angle screenPiezo sounder for audio feedbackVibration motor for haptic feedback6 gamer input buttons Black and Green CappedMenu button, a reset button and an on/off switchVolume control in the Software main MenuUSB programming port2 expansion ports for the expert level usersdebug port for the expert level usersPower with 3XAA battery holders pre-mounted on the board or via the micro USB connector.<br/>Transparent protective cover pre-fitted to protect the board and screen while allowing the electronics to be seen.<br/>On board regulator to provide a consistent supply to the on-board processor.

This Edge Connector Breakout Board for the BBC microbit gives access to all the important pins on the bottom edge of the BBC microbit.<br/>Looking to do more with your BBC microbit? Unlock its potential with this Edge Connector Breakout Board This breakout board has been designed to offer an easy way to connect additional circuits and hardware to the pins on the edge of the BBC microbit. It provides access to all of the BBC microbit processor pins allowing a lot of extra functionality to be added. The datasheet below includes a helpful diagram explaining the function of every pin on the BBC microbit.<br/>This Edge Connector Breakout Board for the BBC microbit gives access to all of the important pins on the bottom edge of the BBC microbit. 21 pins are broken out in total providing additional I/O lines, direct access to buttons A and B, the LED matrix outputs and the I2C bus. Please refer to the datasheet below for more details.<br/>The BBC microbit pins are broken out to a row of solderable pads. The SCL and SDA pins are separated at the edge of the board providing easy identification. The PCB includes a prototyping area with 3V, 0V and unconnected rows that can be soldered to. This allows the easy connection of switches, sensors and any pull-up or pull-down resistors etc. as required.<br/><br/><b>NB Before use, peel green sticker from the back of the board</b>